Automatic Needle Threader - Singer 64S Manuel D'instruction

EN

Automatic Needle Threader

- Thread upper tension of machine up to the thin wire in front
of the needle clamp.
- Raise the needle to its highest position.
- Set machine to straight stitch.
- Press lever (A) down as far as it will go, and gently insert
the hook of the threader into the eye of the needle by
swinging the lever towards you when it is fully lowered.
- The threader automtically swings to the threading position
(B).
- Pass thread under thread guide (C), from left to right.
- Pass the thread in front of the needle around the hook (D)
from bottom to top.
- Release lever (A), by swinging it away from you & then
pushing it back up to the resting position.
- Pull the thread through the needle eye.
Attention:
Turn power switch to off ("O")!
A
1
A
2
18
B
D
C