Sew 1-Step Buttonholes - Singer 64S Manuel D'instruction

EN

Sew 1-step Buttonholes

Buttonhole sewing is a simple process that provides reliable
results. It is strongly suggested to always make a test
buttonhole on a sample of your fabric before working on your
garment. Stabilizer should alsways be used when making
buttonholes.
Making a Buttonhole
1. Using tailor's chalk, mark the position of the buttonhole on the
fabric.
2. Attach the buttonhole foot and set the Pattern Selector Dial to "
Set stitch length dial to "
width however may need to be adjusted according to the project.
Sew a test first to determine this.
3. Lower the presser foot aligning the marks on foot with the marks
on the fabric (A). (The front bar tack will be sewn first.) (Align the
mark on the fabric (a) with the mark on the foot (b).)
4. Open the button plate and insert the button (B).
5. Lower the buttonhole lever and gently push it back (C).
6. While lightly holding the upper thread, start the machine.
7. Buttonhole stitching is done in the order (D).
8. Stop the machine when the buttonhole cycle has completed.
Making a Buttonhole on Stretch Fabrics (E)
When sewing buttonholes on stretch fabric, hook heavy thread or
cord under the buttonhole foot. When the buttonhole is sewn the
legs will overcast the cord.
1. Mark the position of the buttonhole on the fabric with the tailor's
chalk, attach the buttonhole foot, and set the pattern selector dial
to " ". Set stitch length dial to "
2. Hook the heavy thread onto the back end of the buttonhole foot,
then bring the two heavy thread ends under & to the front of the
foot, insert them into the grooves and temporarily tie them there.
3. Lower the presser foot and start sewing.
*Set the stitch width to match the diameter of the gimp thread.
4. Once sewing is completed, gently pull the heavy thread to
remove any slack, then trim off the excess.
". Set the stitch width at "6". The
".
M
".
b
a
A
E
38
H
P U S
B C
H
P U S
3
4
2
1
D