operation
4
How to Operate Your Compressor
NOTE
Before initial operation, the nebulizer cup assembly should be cleaned
following instructions described in the "Cleaning" section.
WARNING
Before connecting the power cord, make sure the I/O (ON/OFF) switch is
in the O (OFF) position.
The plug is also served to disconnect the device.
Daily Use Operation
CAUTION
The Compressor is designed for intermittent use only. Do not
operate it continuously for more than 30 minutes for a single use without
turning it off and following a cooling period for least 30 minutes.
1.
Before each use inspect the Compressor and nebulizer cup assembly
for damage or wear, replace as needed.
2.
Place the Compressor on a table or other flat stable surface. Be sure you can
easily reach the controls when seated. Do not use this device on the floor.
3.
With the power switch in the O (OFF) position, plug the power cord into an
appropriate electrical wall outlet.
4.
Connect one end of the tubing to the compressor air-outlet connector.
5.
Assemble the nebulizer cup and add indicated medication to the nebulizer's cup
before use.
6.
Attach the other end of the tubing into the air-inlet connector found at the
bottom of the nebulizer cup.
7.
Turn on the Compressor by pressing the power switch to the I (ON)
position and begin treatment.
8.
If treatment needs to be interrupted, simply press power switch to O (OFF)
position.
9.
When the treatment is complete, turn off the compressor by pressing the power
switch to O (OFF) position and unplug the unit from the electrical outlet.
10.
Always unplug this device immediately after use.
11.
Not intended for use with OXYGEN or OXYGEN ENRICHED ATMOSPHERES.
Equipment not suitable for use in the presence of a flammable anesthetic mixture
with air or with oxygen or nitrous oxide. This device has no AP or APG protection.
Not intended for use with oxygen or oxygen enriched atmospheres.
................................................................................................................
DRIVE COMPRESSOR/NEBULIZER MODEL 18090-BE / 18091-BE
................................................................................................................
9