EIBENSTOCK EHR 18 S Notice Originale page 14

During use, always hold the machine with both hands and
ƒ
maintain a safe standing position. Start up and run down the
machine in the mixing container only. Pay attention to the reaction
moment of the machine.
For further safety instructions, please refer to the enclosure.
Electrical Connection
Before starting the machine check the correspondence between voltage
and frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The mixer is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could lead to an excessive power loss and to an
overheating of motor and cable.
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has a M 14 - internal thread.
threads and front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Tool Protection
Wrong handling can cause damages on the tool. Therefore, please always
observe the following instructions:
Only use stirring rods with M14 - internal thread which are recommended by
the producer.
Please consider the max. basket diameters.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
14
Keep