stayer M1010 Instructions D'emploi page 13

Switching on and off
To switch the tool on, press the switch 5 and hold it down.
To switch the tool off, release the switch 5.
Continuous operation
To switch on continuous operation: press the switch 5 up
to the stop and at the same time press the locking button 6.
The switch 5 locks, and continuous operation is activated.
To switch off continuous operation: press the switch 5
again and then let go. The lock on the switch 6 is released,
and continuous operation is deactivated.
Removing tools (mixer)
Fit the flat spanner (22 mm) onto the hexagon of the tool end
piece (mixer) and turn to the left to unscrew the tool from the
spindle.
Motor electronics / Operating
motor electronics
Starting current limiting
The electronically controlled soft start ensures that the
machine starts smoothly. This also prevents spray from thin
liquids when the tool is switched on.
The lower starting current means thar a 16 A fuse is large
enough for the machine.
Gear selector switch
Two speed rangers can be selected with the gear selector
switch 1.
Gear 1: 150 rpm hasta 300 rpm, (1010W 100 rpm to 230 rpm)
Gear 2: 300 rpm hasta 650 rpm, (1010W 230 rpm to 500 rpm)
It is possible to change fear when the machine is running.
However , this should not be done wen the machine is at
full load.
ENGLISH
12
Constant electronics
The constant electronics keeps the speed virtually constant
during idling and under a load. This guarantees thar
materials are mixed uniformly.
Electronic overload protection
An electronic overload devide protects the motor against
damage when the tool is under an extreme load. In this
case, the motor stops and only starts up again when the
feed is reduced or the load removed (only model 1600).
Temperature-dependent overload
protection
To prevent the motor from overheating under an extreme
continuous load, the safety electronics switches the motor
off when it reaches a critical temperature.
After a coolong-down time of around 3 – 5 min., the machine
is ready for operation at full load. If the tool is warm from
operation, the temperature-dependent overload protection
will respond earlier.
Operating Instructions
The choice of stirrer paddle depends on the material to
be stirred. For materials with low viscosity, e. g. , disper-
sion paint, varnish, adhesions, casting compound,
cement grout, etc., use a stirrer paddle with left-hand
spiral.
For materials with high viscosity, e. g., ready-mixe d
plaster, concrete, cement, screed, filler, epoxy resin,
etc., use a stirrer paddle with right-hand spiral.
While mixing, move the power tool in an up and down
motion. Clean the stirror paddle after use.
12