Publicité
Les langues disponibles
Les langues disponibles
EN
Product Safety Information
Intended Use:
This cordless tool can be used as a sander or polisher. As a sander, it is designed to remove material with an attached sanding disc. As a polisher, a
softer accessory, such as a foam or wool pad, is attached and can be used with polishing compound.
•
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious
injury. Save all warnings and instructions for future reference.
•
Responsibly recycle or dispose of Batteries. Do not puncture or burn Batteries. Improper disposal may endanger the environment or cause
personal injury.
•
Only use Tools with appropriate voltage Ingersoll Rand batteries and Charger. Use of any other batteries may create a risk of fire, personal
injury or property damage.
For additional information, refer to Cordless Polisher/Sander Product Safety Manual Form 47542�71001, Battery Charger Safety
Information Manual Form 105�7832 and Battery Safety Information Manual Form 105�7840.
Manuals can be downloaded from ingersollrandproducts.com
Product Specifications
Voltage
Model
V, DC
G1621
12
Model
G1621
† K
= 3dB measurement uncertainty
pA
‡ K
= 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized test standards. The exposure to the user in a
specific tool application may vary from these results. Therefore, on site measurements should be used to determine the hazard level in that
specific application.
Abrasive Installation
●
Always remove the battery pack, before installing, removing or adjusting any accessory on this tool, or before performing any mainte-
nance on this tool or any accessory.
●
Backing Pads should be inspected for signs of irregularities such as fractures, excessive wear, nicks and cuts at the edge of center hole.
Pads showing such characteristics should not be used.
See drawing 1 on page 2.
A
Sanding disc / Polishing pad
B
Backing pad / Hook & Loop pad
C
Spindle lock
For Sanding disc / Polishing pad installation:
1. Press in the spindle lock.
2. Thread backing pad / hook & loop pad onto spindle.
3. Center sanding disc / polishing pad and attach onto backing pad / hook & loop pad.
Switch Lock
The switch lock is an additional safety feature. It locks the trigger and is used when attaching accessories, storing the tool, or when tool is not in use.
See drawing 2 on page 2.
Parts and Maintenance
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
EN-1
Polisher/Sander Product Safety Manual Form 47542�71001, Battery Charger Safety
Product Safety Manual Form 47542�71001, Battery Charger Safety
Free Speed
Battery Model
High (rpm)
BL1203
7600
Sound level dB(A) (EN�0745)
Battery Model
† Pressure (L
BL1203
67
Conforms to UL STD. 60745-1 & 60745-2-3
Certified to CSA STD. C22.2 No. 60745-1 & 60745-2-3
WARNING
Single Thread
Size
Low (rpm)
2200
5/16"-24UNF
)
‡ Power (L
)
p
w
78
WARNING
WARNING
Sanding Disc
Polishing Disc
Diameter
Diameter
(Inch)
(Inch)
2
3
3
Vibration (m/s
)
2
(EN�0745)
Level
*K
3.0
0.8
47540127001_ed2
Publicité
