JVC LT-42EM91 Guide D'utilisation page 13

Connections to other equipment
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the
TV's remote control.
To control the audio, turn on the TV and the stereo amplifier, and turn off the TV's built-in speakers (see page 17).
Rear of the unit
NOTE:
• To hear sound when using an external audio amplifier, the volume of both the TV and the amplifier must be set
above 0 (zero).
• For example, if the volume of the TV is set to 0, you will not be able to hear any sound, even if the volume of the
amplifier is at its highest level.
Using an AV Amplifier with built-in digital surround
If you are using an Amplifier with built-in digital surround sound, you can enjoy various audio systems including
Dolby Digital Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby Digital decoder, etc. as shown below.
Rear of the unit
To DIGITAL AUDIO
COAXIAL OUT
Coaxial digital cable
(not supplied)
To Coaxial
Digital Audio IN
AV Amplifier with built-in digital surround
decoder as listed above
NOTE:
• When you are viewing digital broadcast, this unit will not work in conjunction with DTS audio or MPEG audio.
There will be no sound output if connected to an AV amplifier with a built-in DTS decoder or MPEG decoder.
To VAR. AUDIO OUT
Audio cord (not supplied)
Speaker
Amplifier
To Audio (L) Input To Audio (R) Input
Front
(Left)
Surround
Speaker (Left)
(continued)
Front
Speaker
Subwoofer
(Right)
TV
Center Speaker
Surround
Speaker
(Right)
13