Fagor LFA-019 IX Guide D'utilisation Et D'entretien page 8

4
INTEGRATION
To install a built-in dishwasher:
WORKTOP
If the worktop is made of
a
wood, fit plastic protection
over the worktop, which
prevents the vapors affecting
and damaging this area.
b Fit the veneer to the front part
of the dishwasher in order to
fasten it to the piece of
furniture.
LEGS – LEVELLING
In order to build it into a line
c
of furniture with a single base,
loosen the extra bases and
remove them.
d Bring it to the work top and
raise it by turning the rear feet
away from the front part
leaving a space of around 3
mm with the worktop.
e To finish positioning, adjust
to desired height using the
front feet.
PANELLING
From the accessory bag
f
supplied with the dishwasher,
take the two panel adaptors,
fit them by sliding them along
the groove and fix them with
screws also found in said
bag.
Screw the panel cover
g
(supplied as an accessory)
to the panel adaptors,
adjusting to your desired
height.
a
c
d
f
b
d
e
g