Starting The Chainsaw - FUXTEC FX-KS226 Mode D'emploi Original

Original Bedienungsanleitung Baumpflegesäge FX-KS226_de_en_fr_ita_rev01
• Replace damaged seal immediately!
• Tighten oil cover (5) with seal by hand
• Always wipe up any spilt saw-chain oil
8.

Starting the chainsaw

• Take a secure standing position
• Place the appliance on the floor so that the saw-chain cannot come
into contact with anything
• Activate the chain brake (hand guard audibly engages to the front)
• Grip the handle firmly with one hand and press the device onto the
floor
Cold start
• Set ignition switch (3) to [1]
• Press the fuel pump (15) gently until no more bubbles are visible
(approx. 10×).
• Pull out the choke lever (14) completely
• Pull out the pull starter (6) evenly to the stop until the first ignition
noise is heard
• Push the choke lever (14) back in
• Pull out the pull starter (6) evenly to the stop until the engine starts
• Release chain brake (10)
• Operate the throttle lever (16) slightly
Warm start
• Set ignition switch (3) to [1]
• Pull out the pull starter (6) evenly to the stop until the engine starts
• Operate the throttle lever (16) slightly
• Release chain brake (10)
• If the engine does not start after pulling the pull starter three times,
repeat the entire starting procedure as described under Cold Start
After starting
• Run the engine at idle speed for some time
• Press the throttle slowly to increase the engine speed
When the engine speed is high enough, the clutch disengages and the saw-
chain starts to rotate.
• Ensure that the chain is sufficiently lubricated (► Check chain
lubrication)
• Check that the chain stops spinning when the throttle is released
51