Cleaning And Maintenance - EuroLite LED ML-56 Mode D'emploi

Addressing
Each device occupies 2 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Controlling:
After having addressed all LED ML-56 Spots, you may now start operating these via your lighting controller.
DMX-Protocol
Channel: Characteristic:
1 - Dimmer 0 - 255 / 0 - 100%
2 - Strobe
0 – 15 static
16 – 255 with increasing speed

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
20/40 00029373.DOC, Version 1.1