Electrica Connections Vort T; Vort T Control Box - Configuration Parameters - Vortice VORT T Notice D'emploi

ENGLISH
1 = POWER 220 Vac
2 = POWER 220 Vac
3 = Pr2 ... TEMPERATURE PRObE
4 = GND ... TEMPERATURE PRObE
4 = GND ... GROUND ANEMOMETER
5 = Pr1 ... IOUT 4/20 mA ANEMOMETER
6 = +12V ... +Vcc ANEMOMETER
7 = NO ... CONTACT NO ALARM
8 = C ... COMMON ALARM
9 = NC ... CONTATTO NC ALARM
18 = GND- ...-0 fAN SIGNAL OUTPUT
19 = +10V ... +10Vcc fAN SIGNAL OUTPUT
VORT T CONTROL BOX – CONFIGURATION PARAMETERS
The VORT T control box allows to control the ventilation based on the wind speed
(Mode A) or the temperature (Mode B), by using specific probes. Generally the
controller is equipped with a temperature probe and then adjusted to an operation
in B mode, relying on the temperature present in the environment.
It is possible change mode every moment, following these steps:
Electrical connections VORT T
fAN SIGNAL OUTPUT 0-10V
7