Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
20
Display
F
B
J
K
D
O
G
E
A: When the unit is in the heating standby mode, the
While this indicator is displayed, the indoor fan turns off or on at low fan
speed.
B: The currently selected operation mode is displayed.
C: This is displayed if a different operation mode was selected already by
another remote control unit and indicates that the mode cannot be
changed.
D: After turning on the mains power switch for the first time,
blinks on the display of the remote control unit. While this is displayed, the
system is automatically checking units, and so wait until the
indicator turns off to operate the remote control unit. When the TIMER
SET button is pressed to set the timer, the
E: The currently selected FAN SPEED, fan angle and SWEEP status are
displayed.
F: This is displayed only if an abnormality occurs within a unit.
G: When the CHECK button is pressed for more than 4 seconds, the TEST
indicator appears. Then, press the ON/OFF operation button to start test
run.
H: This is displayed to indicate that the system controller is being used for
control. When
by the system controller.
I: This displays the unit number of the indoor unit selected with the unit
selection button or the indoor/outdoor unit where an error is indicated.
Unit No.
1 — 2
J: This is displayed if it is time to clean the filter.
K: When setting the timer, the selected timer mode is displayed. This displays
the time of the timer. (An alarm message is displayed when an error
occurs.) Pressing the TIMER SET button cycles through the options in this
order:
L: This is displayed when using the remote control unit sensor.
M: This is displayed if a function is unavailable when a button is pressed.
N: This displays the temperature setting.
O: This is displayed when a connected ventilation fan (available
commercially) is operating.
C
H
I
M
A
Description
is flashing on the display, the operation is not accepted
Indoor unit No.
Refrigerant circuit No.
N
L
indicator appears.
indicator
indicator flashes.
No Display
Publicité
Chapitres
Table des Matières
Dépannage
