Maintenance; Changing The V-Belt - Makita DPC 6400 Manuel D'instructions Et De Sécurité

A
SERVICE
B
7
5 6
C
8
D
18
STOP
4
3
2
9

MAINTENANCE

CAUTION:
Before doing any work on the Power Cut turn off the
engine, remove the cutting disc, pull the plug cap off the
spark plug and wear protective gloves!
CAUTION:
Start the Power Cut only after complete assembly and
inspection.
IMPORTANT:
Because many of the parts and assemblies not mentioned
in this Instruction Manual are vital to the safety of the unit,
and because all parts are subject to a certain amount of
wear and tear, it is important for your own safety that you
have the unit checked and maintained regularly by a
MAKITA service center.
IMPORTANT:
If the cutting wheel breaks during cutting, the
Power Cut must be repaired by a MAKITA service
centre before being used again!

Changing the V-belt

Loosen nuts (3).
Loosen the tightening screw (1) (counter-clockwise) until the
end of the screw (2) is visible in the gap.
Unscrew the nuts (3) and remove the cover (4).
Remove the screws (5) and (7) and remove the side piece (6).
NOTE:
Screw (5) is longer than screws (7). Make sure
1
to put them back in the right places during
reassembly!
Unscrew screws (8) and remove the crankcase housing cover
(9).
Remove the old belt (10) or belt pieces. Clean out the inside of
the drive arm with a brush.
Put in a new V-belt.
NOTE:
Reassemble the crankcase housing cover (9), side piece (C/6)
and cover (C/4) in the reverse order.
10
To tighten the V-belt see "Tightening the V-belt / Checking
V-belt tension".