Sennheiser RS 85 Notice D'emploi page 8

Adjusting the volume
Set the volume of your sound source to a medium
value. With some devices, the volume for the
headphone output can be regulated separately.
Use the V control on the right earpiece to
OLUME
adjust the headphones´ volume.
Adjusting the receiver channel
First switch on the transmitter (see section Where
to place the transmitter). Then switch on the
headphone receiver - as soon as the receiver is
switched on it automatically tunes itself to the
first strong signal found (normally the
transmitter frequency). If, for some reason, the
selected channel is not the correct one (eg:
because of interference or another nearby system), press the T
earpiece and the auto-tune function will re-tune to the next strong signal. Repeat this
until you can hear the audio signal loud and clear. If you decide to change the
transmitter channel, the receiver search tuning must be re-started by pressing the
T button on the headphones again.
UNE
Changing the transmission channel
To avoid interference caused by the simultaneous
operation of several transmitters, select a
different channel on each transmitter. Depending
on the system variant, two or three switchable
transmission channels are available.
To select a channel, press the C
the desired LED or LED combination
lights up:
LED 1
LED 2
LED 1 and 2
Complete freedom of movement
It is not necessary that transmitter and
headphone receiver are in a direct line of sight, so
you can move around freely in the home or outside
in the garden. One transmitter can be used to
transmit to several receivers on the same
frequency.
Additional headphones with the designation
HDR 85 are available from your specialist dealer.
Please make sure to choose headphones with the same frequency range as the
transmitter you are using (see type plate on the bottom of the transmitter).
Wireless RS 85-8
button until
HANNEL
channel 1 active
channel 2 active
channel 3 active (except 863 MHz version).
button on the
UNE