Magnat ALPHA RS 8 Mode D'emploi page 9

Level control (5)
This control is used to set the bass volume according to your preferences. Proceed as follows::
1. Set the bass control of your amplifier into its centre (linear) position.
2. Important: Set the level control to its left stop (lowest volume).
3. Now, play back some music and set the volume control of the amplifier to the desired level.
4. Set the subwoofer level control to the desired bass level.
Cross-over frequency control (4)
Used to set the upper limit of the subwoofer operating range. The cross-over frequency should be set
to 50 to 150 Hz when the system is used in combination with shelf loudspeakers or 50 to 100 Hz
when used with stand loudspeakers.
Phase switch (1)
In normal use the phase switch should be set to 0°. However, in rare cases it may be advantageous
to set the phase to 180° (e.g. if the subwoofer is far away from the front loudspeakers or in the event
of unfavourable acoustics in the room). Generally speaking: the setting where the lower base tone
area has a fuller sound is the correct one.
MAINTENANCE
The surface is best cleaned with a mild household cleaner. On no account use furniture polish or
similar products.
SPECIFICATIONS
Configuration:
Fitted with:
Output power RMS/Max.:
Frequency range:
Cross-over frequency:
Dimensions (WxHxD):
Accessories:
Subject to technical change.
Alpha RS 8
Bass reflex, frontfire
200 mm woofer
80 / 160 watts
25 – 200 Hz
50 – 150 Hz, adjustable
260 x 350 x 370 mm
mains cable
9 9
Alpha RS 12
Bass reflex, frontfire
300 mm woofer
120 / 240 watts
20 – 200 Hz
50 – 150 Hz, adjustable
360 x 485 x 460 mm
mains cable