Select Temperature - Maytag Commercial MVWP575GW Guide D'utilisation Et D'entretien

7.

Select TEMPERATURE

Once you select a cycle, select the desired wash temperature
by turning the Temperature knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Temperature
Hot
Some cold water is added to save
energy. This will be cooler than your
hot water heater setting.
Warm
Some cold water will be added, so this
will be cooler than what your previous
washer provided.
Cool
Warm water may be added to assist
in soil removal and to help dissolve
detergents.
Cold
This is the temperature from your faucet.
If your tap cold water is less than 50°F
(10°C), warm water may be added to
assist in soil removal and help dissolve
detergent.
Tap Cold
This is the temperature from your faucet.
8
8.
Select any other cycle options you may wish to add, if not
previously set. These may be turned off if desired.
NOTE: Not all options are available with all cycles.
9.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate-to-light
soils
Colors that bleed
Press the START/PAUSE button to start the wash cycle. When
or fade
the cycle has finished, the Done indicator will light. Promptly
Light soils
remove garments after cycle has completed to avoid odor,
reduce wrinkling, and avoid rusting of metal hooks, zippers,
and snaps.
Dark colors that
bleed or fade
NOTE: If you press Start/Pause to pause cycle, you must
Light soils
press Start/Pause to resume cycle. If you hold Start/Pause for
more than 3 seconds, it will cancel your cycle and drain the
washer.
Adding a Garment After Cycle Begins
Dark colors that
During Fill and Soak/Wash, open the lid, add a garment, and
bleed or fade
close the lid.
Light soils
IMPORTANT: If the lid is left open for more than 10 minutes,
the water will pump out automatically.
Select OPTIONS
Press START/PAUSE to begin
wash cycle
START / PAUSE
HOLD 3 SECONDS
TO CANCEL