CONTROL PANEL AND FEATURES
1
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
Knob does not advance during the progress of the cycle –
see cycle status lights for each stage of the process.
See "Cycle Guide" for detailed descriptions of cycles.
Select the cycle most suitable for your load. Items need
to move freely. Tightly packing can lead to poor cleaning
performance and may increase wrinkling and tangling.
TEMPERATURE
2
Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results, and following
the garment label instructions, use the warmest wash
water safe for your fabric.
• Normal, Warm, and Hot water may be cooler than your
previous washer. Deep Water cycles will provide higher
temperatures for the wash cycle.
• Even in a cold or cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
OPTIONS
3
You may add or remove options for each cycle. Not all
options can be used with all cycles, and some are preset
to work with certain cycles.
EXTRA RINSE
This option can be used to automatically add a second
rinse to most cycles.
PRESOAK & EXTRA RINSE
Use this option to add both an extra soak period to any
cycle and a second rinse to most cycles.
PRESOAK
Use this option to add an extra soak period to any cycle to
help loosen tough stains. The washer will agitate briefly, fill
and pause to soak, then begin the selected cycle.
4
1
5
Not all features and options are available on all models.
Appearance may vary.
4
4
START/PAUSE BUTTON
Press to start the selected cycle. To unlock the lid during
Final Spin, press to pause the cycle. Press and hold for
3 seconds to cancel a cycle.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid.
CYCLE STATUS LIGHTS INDICATOR
5
SOAK/
FILL
STATUS
WASH
The Cycle Status lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from traditional washers.
FILL
This LED remains illuminated during the Fill portion of the
cycle.
SOAK/WASH
This LED remains illuminated during the Soak/Wash
portion of the cycle.
RINSE
This LED remains illuminated during the Rinse portion of
the cycle. Fabric softener can be added at this stage of
the cycle.
FINAL SPIN/LID LOCKED
The Final Spin LED and the Lid Locked LED will both
remain illuminated during this portion of the cycle. If you
need to open the lid prior to cycle completion, press and
hold START/PAUSE for 3 seconds.
DONE
This LED illuminates when the cycle is complete and will
turn off when the lid is open.
2
3
FINAL
LID
RINSE
DONE
SPIN
LOCKED