Alecto DVC-125IP Mode D'emploi page 28

3. TO MOUNT THE CAMERA ON A FIXED SPOT.
The camera can be mounted onto a fixed wall.
Attention: Make sure the camera is already registered to the Wi-Fi network.
When the camera is installed and then connected to the mains, it'll re-establish
the connection with the network. If a wired network connection can be used after
mounting the camera, this will not be necessary.
Underneath the foot of the camera you'll found a mounting panel for installing
the camera. On this foot the text 'open' is shown. At the bottom, use a small
screwdriver to remove the metal plate from the foot.
Place the foot onto a flat, hard surface and use screws to fix the plate with
the vaulted side of the feet downward. Now click the camera onto the foot.
First attach the side without cut-out and then the rest (in the opposite direction
compared to removing it) until the camera is secured.
28