Steba LE 160 Mode D'emploi page 15

4. Adjusting the humidity
Press the key to set the desired humidity (RH50%,60%,70%,80%AU,CO). The adjus-
ted humidity is shown at the display for a short time. Then the display switches and
the humiditiy of the room is shown. When the room humidity is 3% less than the set
humidity the compressor of the unit will turn off automatically. When the humidity
of the room is getting 3% higher than the set humidity, then the compressor will re-
start again automatically. If the „Run" lamp is blinking, then the compressor does not
work. The humiditiy in the room is lower than the adjusted value. If the "Run" lamp is
permanently on, then the compressor is working.
Comfort mode (indicate AU in the display)
a) When ambient temperature is below 5, the compressor will stop working.
b) When ambient temperature is at or above 5 and below 20,the appliance will auto-
matically set the humidity level at 60%.
c) When ambient temperature is above 20 and below 27, the appliance will automati-
cally set the humidity level at 55%.
d) When ambient temperature is above 27,the appliance will automatically set the
humidity level at 50
5. TANK FULL
If this indicator (WF) illuminates, it means tank is full of water, and unit will operate
with fan only(The compressor will stop running automatically, until the tank
is emptied).
PRECAUTIONS
1. The dehumidifier shall not operate if the humidity setting is higher than the ambi-
ent humidity.
2. Drain the water in the water storage tank when the water in the tank is full and
the water level indicator light(WF) illuminates. Then install the empty water tank
back to its position, so the unit can continue its operation.
3. When the unit stops, you have to wait for 3 minutes before you can restart the
unit to protect the compressor from damage.
4. The operational temperature range for this unit is 5-35 C°.
5. If the dehumidifier does not start (The „Run" light is blinking or off) or the de-
humidifier makes intermediate stop on unknown reasons, please check the plug
and power supply for poor connection. If the plug and power supply are in normal
condition, wait for 10 minutes and restart the unit (because take about 10 minutes
to reposition). If the unit still does not start in 10 minutes, please contact your local
distributor service station for repair.
6. When the dehumidifier is in operation, the running compressor will produce heat
and make the room temperature higher. That is normal.
15