Publicité
Les langues disponibles
Les langues disponibles
Attention! In case of overheating, risk of fire! Keep a
∙
safety distance of min 60cm to wet areas (e.g. Shower,
bath tubes, sinks) and min 120cm to water taps!
1. Operation:
∙ When the unit is unpacked, place the appliance vertical on the floor and leave it for
12h, that the cooling liquid is bubble free
∙ Take care that the water tank is inserted correctly.
∙ Turn the humidity regulator is turned to "Off"
∙ Plug the appliance in with dry hands.
∙ Ensure that the ventilation openings are open.
∙ Press the ON/OFF button
humiditiy of the room is shown in the display. The dehumidifier is programmed to
start with continuous dehumidification (CO). Important: When the unit is un-
plugged then the appliance will start the next time with the programmed setting.
The light "Operation" is flashing. In the display "Low" is shown, after that the
humidity of the room. The compressor starts working from a humidity higher than
50%.
∙ The compressor is only working when the real humidity in the air is higher than the
adjusted.
∙ The unit is suitable to work at temperatures from 5°C to 31°C.
∙ The humidity performance is depending on the surrounding humidity and tempe-
rature. A good dehumidification is achieved at temperatures higher than 22°C and
a humidity above 70%.
∙ When the dehumidifier reaches the adjusted value, the compressor will stop wor-
king and starts again when the humidity is again above the programmed value.
∙ Keep doors and windows closed of the room which should be dehumidified.
∙ Take care that nothing can drop on the appliance.
∙ During use, the appliance will create warm air.
∙ To run the appliance continuously, turn the humidity regulator to "cont".
2. Air speed:
The air speed can be changed, by pressing the button "Speed". In the display "Hi" is
shown for air speed or "Low" for low air speed. The adjusted air speed is shown in
the panel with "High" or "Low" lamp.
3. Timer:
a) When the time should be adjusted, then press the "Timer" button. The time can
be adjusted in steps of one hour from one to 24hours. The „Timer" lamp at the
panel is on.
b) When the time runs out then the appliance will switch off automatically.
c) When the appliance will be switched off by pressing the "Power" button before
the timer runs out, then the rest time of the timer will be deleted.
. The „Hi" lamp is on and the „Run" is blinking. The ca
13
Publicité
