Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NB-IoT PULSE - Guide utilisateur / User guide version V1.0.0
5.
PREPARATION
5.1. Dismantling the case
The product is supplied disassembled such that the lower electronic part can be accessed. This part
is where the meter or meters are connected to the screw terminals and where the micro USB port for
configuration of the device.
Once connection of the meters has been finalized and configuration carried out, the case may be
closed.
5.2. Installation of the compression seal
Before connecting your meter cables to the product's screw terminals, you must insert the compression
gland nut and the appropriate seal for your configuration.
2 types of seals are supplied with the PULSE: for a 5 mm diameter cable and for a 4 mm diameter ca-
ble.
Assembly procedure:
1 - Your meter
2 - Pass the
and its pulse
cable through
interface.
the compres-
sion gland nut.
Joint 1 câble dia: 5,4 mm
3 - Pass the
cable through
the compression
gland seal
Joint 1 câble dia: 4,2 mm
4 - Pass the ca-
5 - Connect
ble through the
the ends of
PULSE'S case
the meter
plate.
cable to the
screw termi-
nals.
FR
EN
Page
53
of 56
Publicité
Table des Matières
