TE B-450-HS Série Mode D'emploi page 22

8. LOADING THE PAPER
Setting the feed gap sensor position
1 Move sensor knob A in a horizontal direction so that the
centre of the label gap. Remember the number that the centre of the sensor knob A is positioned at.
Set sensor knob B to the same position number.
2 Release the lock lever in the direction indicated by the arrow, and gently lift the sensor cover.
NOTE: Lift the sensor cover gently so that it does not touch the ribbon.
3 Set the sensor knob B to the same position # of the sensor knob A.
NOTE: Sensor knobs A and B are set to position #3 where the black mark is centred on the label width
as a default. Do not change the position of sensor knobs A and B except when changing the sensor
detecting position. Be sure to set the sensor knobs A and B to the same position #. Failure to do
this may cause a paper feed error and paper end detecting error.
4 Draw the label onto the platen. Close the sensor cover and return the lock lever to lock the sensor cover
tight.
Sensor Cover
E8-6
ENGLISH VERSION EO1-330020
mark on the sensor cover aligns with the
The centtre of the gap
1 2 3 4 5
Feed Gap Sensor Position
8. LOADING THE PAPER
Sensor
Knob A
Fig. 8-14