Installation Procedure; Installing The Supply Holder Unit; Installing The Supply Cover - TE B-450-HS Série Mode D'emploi

6. INSTALLATION PROCEDURE

6. INSTALLATION PROCEDURE

6.1 INSTALLING THE SUPPLY HOLDER UNIT

Turn the power OFF before installing the supply holder unit.
Fit the two studs on the bottom of the printer into the holes in the supply holder unit.
Supply Holder Unit

6.2 INSTALLING THE SUPPLY COVER

Fit both hooks of the supply cover onto the shafts of the supply holder, and then gently close the supply
cover. (Refer to Fig. 6-2)
NOTE: After this section, the supply cover will be removed in photos and figures. Please understand
that it provides clearer descriptions.
WARNING!
E6-1
ENGLISH VERSION EO1-33020
6.1 INSTALLING THE SUPPLY HOLDER UNIT
Fig. 6-1
Supply Cover
Hook
Fig. 6-2
Shaft