Use - Mr. Magic Z 03024 Mode D'emploi

EN

Use

ATTENTION!
■ Risk of injury associated with sharp blades! Never hold the cross-blade adapter
by the blades. Handle the cross-blade adapter with care in order to prevent cut inju-
ries.
■ Risk of damage due to insuffi cient cooling! Never place the motor unit on a soft
base. The vents on the side and bottom of the motor unit must not be covered.
■ Burn hazard! Never fi ll the blending container with boiling hot food or liquids! The
content must not be warmer than 50 °C.
■ Before you use the device, make sure that all parts of the device are properly seated.
■ The maximum fi lling capacity of the blending container amounts to 500 ml. Do not
overfi ll it. Keep an eye on the MAX mark on the blending container!
■ Always fi rmly hold the motor unit with one hand during preparation.
■ Always pull the mains plug out of the socket and let the blades come to a full stop
prior to removing the blending container.
■ The device must not be transported when switched on.
■ Do not leave the device switched on continuously for more than 1 minute. Then allow
it to cool off for 2 minutes before continuing.
1. Place the motor unit on a dry, level and solid base.
9. Turn the blending container over and screw the cross-blade adapter off.
10. Clean the accessories immediately after each use to prevent the formation of germs
(see chapter "Cleaning and storage"). Do not allow any residual food to dry onto it.
03024_DE-GB-FR-NL_A5_V2.indb 16 03024_DE-GB-FR-NL_A5_V2.indb 16
16
2. Place the desired ingredients in the blending container (do
not exceed the MAX mark in the blending container!).
3. Screw the cross-blade adapter up to the stop on the blending
container.
4. Turn the blending container upside down and place the cross-
blade adapter in the motor unit. The 3 catches on the blend-
ing container must be inserted in the corresponding recesses
in the motor unit for this.
5. Connect the mains plug to a properly installed, easily acces-
sible socket.
6. Switch the device on. To do so, gently push the blending con-
tainer down and, at the same time, turn it clockwise until it
locks into place. Always hold the motor unit fi rmly with one
hand during preparation!
7. To switch the device off, turn the blending container counter-
clockwise up to the stop.
8. Wait until the blades have come to a complete stop. Then
remove the blending container.
14.01.2016 13:35:01 14.01.2016 13:35:01