Mr. Magic Z 03024 Mode D'emploi page 13

■ The device should never be set up when highly fl ammable materials are nearby (cur-
tains, textiles, etc.).
■ Do not place any fl ammable materials such as paper, cardboard or plastic in or on
the device.
■ Never submerge the motor unit in water or other liquids! Make sure that the motor
unit, the cord or the plug can not fall in water or get wet.
■ If the motor unit falls in water, immediately disconnect the power supply.
■ Never touch the motor unit, the cord or the plug with wet hands.
■ Only connect the device to a socket, which has been properly installed and complies
with the device's technical data (see chapter "Technical data").
■ Lay the cord such that it is not crushed or creased and such that it does not come into
contact with hot surfaces.
■ Pull the mains plug out of the socket if you do not use the device, if a defect occurs
while in use or before a storm.
■ If you want to remove the mains plug from the socket, never pull on the cable, but
always on the plug.
Beware of damage to the device and property
■ Check the device for damages prior to each use. The device must not be used if the
motor unit, the accessories, the mains cord or plug exhibit visible damages. Do not
attempt to repair the device or replace the cable and/or plug yourself. In the event of
damage, promptly contact the customer service department.
■ Each time before using the device, check whether the device is clean and dry and
whether it has been correctly assembled and closed.
■ Do not use any additional accessories. Only use the enclosed accessories from the
manufacturer.
■ Do not let the motor run if the device is empty.
■ Make sure that the maximum fi lling capacity (MAX mark in the blending container) is
not exceeded!
■ Do not leave the device unattended when in operation.
■ The device must not be transported when switched on. Always pull the mains plug
out of the socket and allow the motor to come to a full stop prior to moving the device.
■ Do not allow the device to fall and do not subject it to strong percussions.
■ Do not subject the device to extreme temperatures, severe changes in temperature,
direct sunlight or moisture.
03024_DE-GB-FR-NL_A5_V2.indb 13 03024_DE-GB-FR-NL_A5_V2.indb 13
13 EN
14.01.2016 13:35:00 14.01.2016 13:35:00