Siemens DE527M Série Notice D'utilisation page 7

Operating the appliance
Switching the appliance on and off
The continuous-flow heater switches on and heats the water
when the warm water tap is opened. It switches off again if
the water tap is closed.
Setting the water temperature
Turn the rotary selector switch.
Any desired temperature can be set between 30 °C to
60 °C in increments of 0.5 °C.
The display shows the selected temperature.
Note: The displayed temperature is the water temperature
inside the appliance. The temperature of the water leaving
the tap can vary from this due to heat losses in the pipework.
Error message in the display
If an error message "E.." appears in the display or an LED
flashes, see chapter "A fault, what to do?".
Solar heated
The appliance can be operated with pre-warmed water (for
example, from a solar energy unit).
Attention!
Scalding danger!
If the output temperature of the water leaving the tap
is higher than the set temperature, then this is because
the supply water temperature from the domestic sys-
tem is too hot, e. g. due to its being heated by a solar
energy unit.
The thermostatic premixer in the domestic supply must be
set accordingly to lower temperatures.
Startup after power failure
Open the warm water tap fully and allow water to flow
until it is warm.
Using the appliance after switching off
the water supply
Switch off the appliance (unscrew the fuse in the
fusebox).
Open the warm water tap and keep it open until the air
has been completely forced out of the water pipe.
Switch the fuse back on again.
Open the warm water tap fully and allow water to flow for
at least one minute,
Only then (for safety reasons) will the appliance begin to
heat. The appliance is now ready to operate.
en
Saving energy
Set the desired water temperature directly on the
appliance.
Note: Mixing in of cold water at the faucet/fitting consumes
unnecessary water and energy.
This also accelerates calcification (scaling) of the appliance.
Therefore, please always set the desired temperature directly
on the continuous-flow heater.
Winter operation
Note: It is possible in winter that the supply temperature of
the water is reduced and the required outlet temperature is
no longer achieved.
Reduce the water flow on the taps until the desired water
temperature is reached.
Cleaning
Only wipe off the appliance using a moist cloth.
Do not use acidic or abrasive cleaning materials.
Do not use a steam cleaner.
Customer Service
We ask you to always provide the E-No. and the FD-No. of
your appliance when calling in a customer service engineer.
You will find the numbers on the ratings plate on the inner
side of the front flap.
The contact information for your country can be found on
the last pages of these instructions.
Environmentally-friendly disposal
Dispose of the packaging in an environmentally sound
manner.
This appliance is labelled in accordance with Euro-
pean Directive 2012/19/EU concerning used elec-
trical and electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the framework for the
return and recycling of used appliances as appli-
cable throughout the EU.
Please ask your specialist retailer about current
disposal facilities.
Subject to change without notice.
7