Temperature Control; Lighting; User Maintenance; Cabinet Cleaning - Accucold ACR1515SS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TEMPERATURE CONTROL

The temperature is controlled by a thermostat which is located on the front ventilation louvers, just below
the door. The thermostat has been factory-set to keep the product between 35.6 and 46.4°F (2 and 8°C).
The thermostat normally displays the temperature inside the cabinet.
To change the set temperature, push the middle button on the thermostat until the previous set
temperature is displayed. Push the upper or lower button until the desired temperature value is shown.
Finally, push the middle button again to select the setting.
To find out about changing other parameters, call our Customer Service Line at 1-800-932-4267.

LIGHTING

Cabinet lighting is designed to function continuously or may be controlled with a switch, located inside the
unit to the left of the internal fan in the ceiling. See Wiring Diagram, page 8. Fluorescent lighting surrounds
the glass on the interior side of the door. Additionally, the header panel above the door is backlit.
NOTES:
If the unit is unplugged, or power is lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
When you use the unit for the first time or restart the unit after it has been shut off for a long
time, allow a few hours for the interior temperature to normalize.
For better performance and user convenience, this refrigerator has been designed to function with the least
possible maintenance and to provide optimal energy consumption and serviceability. It is recommended,
however, that the unit be kept clean and that the following preventative maintenance be performed.

CABINET CLEANING

Turn off the power, unplug the appliance, and remove all items, including shelves and shelf clips.
When cleaning cabinet interior, use a solution of warm water and mild soap.
Do not use steel wool, caustic or abrasive cleaners or bleach that may damage the stainless surface.
Once the cabinet interior is clean, dry it with a clean, dry cloth.
Wipe the door gasket with a solution of warm soapy water, then dry with a clean soft cloth.
Wash the shelves with a mild detergent solution, then dry them.
Wring excess water out of the sponge or cloth when cleaning the area where the controls are located,
or any electrical parts.
Clean the outside of the unit with an approved stainless steel cleaning product. Do not use steel wool
or a steel brush on the stainless steel surfaces.
NOTE: Do not use alcohol derivatives or thinner to clean the cabinet.
CAUTION: Failure to unplug the appliance during cleaning could result in
electrical shock or other personal injury.

CONDENSER CLEANING

Disconnect the refrigerator's power supply before cleaning. The static condenser (on back of unit) should
be cleaned every 12 months for optimum performance. Use a soft-bristle brush to remove excess dust to
improve heat transfer to the surrounding air.

USER MAINTENANCE

10

Publicité

Chapitres

Table des Matières
loading

Table des Matières