Publicité
Les langues disponibles
Les langues disponibles
Cleaning the Condenser
Disconnect the refrigerator's power supply before cleaning.
The static condenser (on back of unit) should be cleaned every
12 months for optimum performance. Use a soft-bristle brush to remove
excess dust to improve heat transfer to the surrounding air.
Cleaning the Alarm/Thermostat
●
Do not wash or expose the alarm/thermostat to
water or other liquids.
●
Clean the product by wiping with a soft, dry cloth.
●
Never use volatile or abrasive liquids or cleaners
to clean the product.
●
Do not subject the product to sudden shock or
impact.
The compressor and fan are located behind the front
louvers of the appliance.
To clean the compartment behind the front louvers,
Disconnect the power supply to the
1.
appliance.
Remove the two screws, as shown above.
2.
Life the front louver panel, then pull it toward you, being careful not
3.
to disconnect any attached wiring.
Clean the area with a damp cloth, then dry it.
4.
Replace the louver panel and screw it back into place.
5.
Reconnect power to the appliance.
6.
Defrosting
It is not necessary to defrost your refrigerator. This is done automatically, using a forced-air system.
There is a defrost water evaporation pan in the compartment below the main cabinet. A hot gas line
from the compressor passes through this pan and evaporates the water. Check occasionally that the
drain hose is always inside the evaporation pan.
Security Lock
Your unit is provided with a lock and key combination. The lock may be found on the front of the
refrigerator. The keys are located inside the plastic bag that contains the User Manual. After a key
has been used, remove it, and put it in a secure place for safekeeping.
10
Publicité
