Royal RPC 2045 Mode D'emploi page 20

Anleitung_RPC_2045_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Chain bar
2. Saw chain
3. Chain tensioning screw
4. Stop claw
5. Chain brake lever / front hand
guard
6. Front handle
7. Starter handle
8. Spark plug (under the air filter cover)
9. Air filter cover
10. Stop switch
11. Safety lock
12. Oil tank cap
13. Fan housing
14. Fuel tank cap
15. Rear handle / bootstrap
16. Chain guard
17. Choke / (carburetor setting)
18. Bar fastening nut
19. Throttle lever
20. Chain catch
20
12.10.2011 7:43 Uhr Seite 20
Safety features (fig.1)
2 LOW KICKBACK SAW CHAIN helps significantly
reduce kickback, or the intensity of kickback, due
to specially designed depth gauges and guard
links.
5 CHAIN BRAKE LEVER / HAND GUARD protects
the operator's left hand in the event it slips off the
front handle while saw is running.
5 CHAIN BRAKE is a safety feature designed to
reduce the possibility of injury due to kickback by
stopping a moving saw chain in milliseconds. It is
activated by the CHAIN BRAKE lever.
10 STOP SWITCH immediately stops the engine
when tripped. Stop switch must be pushed to ON
position to start or restart engine.
11 SAFETY TRIGGER prevents accidental
acceleration of the engine. Throttle trigger (19)
cannot be squeezed unless the safety latch is
depressed.
20 CHAIN CATCHER reduces the danger of injury in
the event saw chain breaks or derails during
operation. The chain catcher is designed to
intercept a whipping chain.
Note: Study your saw and be familiar with its parts.
3. Proper use
The chain is designed exclusively for sawing wood.
You may only fell trees if you have received the
appropriate training. The manufacturer cannot be
held liable for damage caused by improper or
incorrect usage.
Residual hazards
Even when the equipment is used properly, a certain
residual hazard cannot be ruled out. The following
potential dangers may arise in connection with the
equipment's design and construction:
Contact with the unguarded saw chain (injuries
through cutting)
Reaching into the saw chain while it is running
(injuries through cutting)
Unforeseen, sudden movement of the cutter rail
(injuries through cutting)
Catapulting of parts of the saw chain
Catapulting of parts of the material being cut
Damage to hearing if the compulsory hearing
protection is not used
Inhalation of particles from the material being cut,
emissions from the combustion engine
Skin contact with petrol