Ryobi P2803 Manuel D'utilisation page 13

NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 For use with most consumer grade home and garden
chemicals such as insecticides, fungicides, weed killers,
and fertilizers
INSTALLING/REMOVING BATTERY PACK
See Figure 6.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Align the raised rib on the battery pack with groove in the
battery port and place the battery pack in the tool.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
tool before beginning operation.
To remove:
 Depress the latches on both sides of the battery pack to
release the battery pack and remove it from the tool.
WARNING:
Risk of fire or explosion. Spray area must be well-venti-
lated and away from sparks or flames.
TURNING THE SPRAYER ON/OFF
See Figures 7 - 8.
 To turn the sprayer ON, depress the ON/OFF button.
 To start the flow of liquid at the spray wand, depress the
trigger.
 To stop the flow of liquid at the spray wand, release the
trigger.
 To turn the sprayer OFF, depress the ON/OFF button
again.
OPERATION
LOCK-ON
See Figure 8.
The lock-on feature is convenient when spraying for an ex-
tended period of time or when covering a large area.
 To lock-on, depress the trigger and slide it forward.
 To release the lock-on, depress the trigger and slide it
backward.
NOTE: Make sure the trigger is not locked on before
inserting the battery pack into the sprayer.
FILLING THE TANK
See Figure 9.
Always follow the chemical manufacturer's instructions
printed on their product labeling for use, cleaning, and
storage. Clean thoroughly after each use, following the
instructions in the Maintenance section of this manual.
Chemicals should be stored out of the reach of children.
Failure to do so may result in serious personal injury.
Liquids to be sprayed must be as thin as water. Thicker
liquids will not spray properly.
Do not overfill the tank.
 Remove the battery pack.
 Unscrew the measuring cap and remove it from the tank.
 Fill the tank with the desired amount of water (up to
2 gallons).
 Measure the recommended amount of liquid. The
measuring cap may be used for measuring up to 4 oz.
 Carefully pour the liquid into the tank.
 Rinse the measuring cap with clean water.
 Screw the measuring cap back onto the sprayer, making
sure it is tightened securely.
 Reinstall the battery pack.
Spray solutions may be premixed and poured into the
sprayer, using a funnel if needed.
NOTE: If using a measuring container other than the mea-
suring cap, or if using a funnel to fill the tank, be sure to
thoroughly clean and rinse these items after use. If premix-
ing the spray solution, rinse the container used for mixing.
NOTICE:
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.
9 — English
WARNING: