Spraying; Spraying Technique; Practice - Titan IMPACT 1140 805-011 Notice D'utilisation

Spraying

POSSIBLE INjEcTION haZaRD. Do not spray
without the tip guard in place. Never trigger the
gun unless the tip is in either the spray or the
unclog position. always engage the gun trigger
lock before removing, replacing, or cleaning tip.

Spraying Technique

The following techniques, if followed, will assure professional
painting results.
Hold the gun perpendicular to the surface and always at equal
distance from the surface. Depending on the type of material,
surface, or desired spray pattern, the gun should be held at a
distance of 12 to 14 inches (30 to 35 cm).
Move the gun either across or up and down the surface at a
steady rate. Moving the gun at a consistent speed conserves
material and provides even coverage. The correct spraying
speed allows a full, wet coat of paint to be applied without runs or
sags.
Holding the gun closer to the surface deposits more paint on
the surface and produces a narrower spray pattern. Holding the
gun farther from the surface produces a thinner coat and wider
spray pattern. If runs, sags, or excessive paint occur, change to
a spray tip with a smaller orifice. If there is an insufficient amount
of paint on the surface or you desire to spray faster, a larger
orifice tip should be selected.
Maintain uniform spray stroke action. Spray alternately from left
to right and right to left. Begin movement of the gun before the
trigger is pulled.
start pull
stroke trigger
Avoid arcing or holding the gun at an angle. This will result in an
uneven finish.
Too Thick
Arcing
English
release end
trigger stroke
Offspray
Gun at angle
Proper lapping (overlap of spray pattern) is essential to an even
finish. Lap each stroke. If you are spraying horizontally, aim
at the bottom edge of the preceding stroke, so as to lap the
previous pattern by 50%.
1st 2nd
pass pass
For corners and edges, split the
center of the spray pattern on
the corner or edge and spray
vertically so that both adjoining
sections receive approximately
even amounts of paint.
When spraying with a shield,
hold it firmly against the surface. Angle the spray gun slightly
away from the shield and toward the surface. This will prevent
paint from being forced underneath.
Shrubs next to houses should be tied back and covered with a
canvas cloth. The cloth should be removed as soon as possible.
Titan gun extensions are extremely helpful in these situations.
Nearby objects such as automobiles, outdoor furniture, etc.
should be moved or covered whenever in the vicinity of a spray
job. Be careful of any other surrounding objects that could be
damaged by overspray.

Practice

1. Make sure that the paint hose is free of kinks and clear of
objects with sharp cutting edges.
3. Set the pressure to minimum by turning the pressure
control knob to the "Min" setting in the yellow zone.
3. Move the PRIME/SPRAY valve up to its SPRAY position.
4. Turn the pressure control knob clockwise to its highest
setting in the green zone. The paint hose should stiffen as
paint begins to flow through it.
5. Unlock the gun trigger lock.
6. Trigger the spray gun to bleed air out of the hose.
7. When paint reaches the spray tip, spray a test area to
check the spray pattern.
8. Use the lowest pressure setting
necessary to get a good spray
pattern. If the pressure is set
too high, the spray pattern will
be too light. If the pressure is
set too low, tailing will appear
or the paint will spatter out in
gobs rather than in a fine spray.
8
Overlap edges
3rd 4th 5th
pass pass pass
Good spray pattern
Paint tailing pattern
© Titan Tool Inc. All rights reserved.