Télécharger Imprimer la page

ADURO 15-2 Mode D'emploi page 22

Masquer les pouces Voir aussi pour 15-2:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

_______________________________________________________________________________________________________________________________
Please note: that the Aduro 15-2 must be installed on a floor with the adequate load-bearing capacity. If the
existing construction does not meet this requirement, appropriate adaptation measures must be taken (e.g. a load-
distributing plate).
If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be
placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the wood burning
stove, and 15 cm on each side.
2.2 Pipe connection
Aduro 15-2 leaves the factory with the flue outlet mounted on the top.
A flue pipe with an internal diameter of 150 mm should be used for Aduro stoves.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, a curved flue pipe should be used via the top outlet. After
measurement, a hole is made in the chimney in which the pipe sleeve is placed and fireplace mortar is used to seal
it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed between the flue
pipe and the pipe sleeve to seal the joints. The flue pipe should protrude 5–10 cm into the pipe sleeve, but must not
block the opening in the chimney (see the illustration below).
X
The wood burning stove can be connected to a chimney to which other heat sources are connected.
2.4 Safetywire
The stove comes with a safety wire. Following are step by step instructions how to mount the safety wire (see
below):
1. Mount the bracket on the wall central to the stove
For Aduro 15-2: ca. 53 cm above the floor hearth.
2: Slide the safety wire through the two oblong holes in the backplate of the stove as well as through the eye in the
wall bracket. The safety wire ends must be secured in the rectangular wirelock.
3: The lenght of the wire is adjusted and the wirelock tightened. Excess wire is cut off. In case the wire should be
real tightened, the stove can temporarily be pushed slightly against the wall, while the wire is tightened.
22

Publicité

loading