Care and Maintenance
1. Be sure to unplug the unit before cleaning or servicing.
2. Do not use gasoline, paint thinner or other chemicals to clean the
unit.
3. Do not wash the unit directly under a tap or using a hose. It may
cause electrical damage.
4. If the power cord is damaged, contact the service depot immediately.
AIR FILTER
UNIT ENCLOSURE
LONG-TERM STORAGE
Fig.25
IMPORTANT
Clean the air fi lter at least once every two weeks. Accumulation of dust will hinder fan operation.
REMOVAL
This unit has two fi lters. Lift the upper fl iter out in the direction of the arrow (Fig. 25), then down.
Remove the lower fi lter by loosening the screw and lifi ng out the fi lter as shown in Fig. 25.
CLEANING
1. Wash the air fi lter by submerging it gently in warm water (about 40°C / 104° F) with a neutral
detergent.
2. Rinse the fi lter and let it dry.
REINSTALL
Install the upper air fi lter after cleaning, and install the lower fi lter after, using the screw (see Fig.
26). *Filters should dry before installing*
NOTE: The upper (lower) grills and the upper (lower) air fi lters are connected and can be separat-
ed
Use a lint-free cloth soaked with neutral detergent to clean the unit enclosure,
be sure to wring the cloth of excess water. Finish by wiping with a clean dry
cloth.
•
Remove the rubber plug at the back of the unit and attach a hose to the drain
outlet. Place the open end of the hose directly over the drain area in your base-
ment fl
oor.
•
Remove the plug from the bottom drain outlet, this means that all the water in
the bottom drain tray will drain out.
•
Keep the appliance running on FAN mode for half a day in a warm room to dry
the appliance inside and prevent mold formation.
•
Turn off the appliance and unplug it, wrap the cord and bundle it with tape.
•
Remove the batteries from the remote control.
•
Clean the air fi lter and reinstall it.
Upper filter
(Take out)
Lower filter
(Take out)
Fig.26
14
Upper filter
(Install)
Lower filter
(Install)