Danby DPA085CB1GDB Guide D'utilisation Et D'entretien page 11

Operating Instructions
OPERATING MODES
COOL mode
- Press the "MODE" button until the "COOL" indicator light comes on.
- Press the UP or DOWN arrow buttons to select your desired
room temperature. The temperature can be set within a range of
17°C-30°C / 62°F-86°F.
- Press the "FAN SPEED" button to choose the fan speed.
DRY mode
-Press the "MODE" button until the "DRY" indicator light comes on.
-Under this mode, you cannot select a fan speed or adjust the temperature. The
fan motor operates at LOW speed.
-Keep windows and doors closed for the best dehumidifying effect.
-Do not use the window hose under this mode.
AUTO mode
- When you set the air conditioner in AUTO mode, it will automatically select cool-
ing, or fan only operation depending on what temperature you have selected and
the room temperature.
- The air conditioner will adjust the room temperature automatically to the tem-
perature point set by you.
- Under AUTO mode, you cannot select the fan speed.
FAN operation
- Press the "MODE" button until the "FAN" indicator light comes on.
- Press the "FAN SPEED" button to choose the fan speed (1 time for LOW, 2
times for HIGH, 3 times for AUTO-FAN).
- The corresponding fan speed indicator light for each speed lights up. All indica-
tors are lit up when AUTO-FAN is selected.
- The temperature cannot be adjusted.
- Do not use the window hose in this mode.
TIMER operation
- To initiate the "Auto-stop" program: When the unit is on, press the Timer
button, the TIMER OFF indicator light will illuminate.
- To initiate the "Auto-start" program: When the unit is off, press the Timer
button, the TIMER ON indicator light will illuminate.
- Press or hold the "UP" or "DOWN " buttons to change the Auto-time by
0.5 hour increments, up to 10 hours, then by 1 hour increments up to 24
hours.The control will count down the time remaining until the unit starts.
- The selected time will register in 5 seconds and the system will
automatically revert back to display the previous temperature setting.
- Turning the unit ON or OFF at any time or adjusting the timer setting
to 0.0 will cancel the Auto Start/Stop timed program.
- When a malfunction (E1,E2, E 4 or P1) occurs, the Auto Start/Stop
timed program will also be cancelled.
SLEEP function
Simply press the sleep button. When in cooling mode, the temperature will
increase by 1°C / 2°F every half our for 1 hour. The unit will then hold this new
temperature for several hours before returning to the original temperature setting
and resuming normal operation.
NOTE: This feature is unavailable in FAN and DRY mode.
7