Water Outlet; Removing The Water Collecting Container; Continuous Or Extended Operation - ATIKA ALE 1200 N Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
W
a
W
a
The water collecting container of the air dehumidifier is equipped
with a float switch which turns off the device when the collecting
container is full.
After 45 seconds, compressor and fan will automatically
stop, and an acoustic signal will sound. The
the fault code E4 will be displayed.
Another acoustic signal will sound every 5 minutes if the
water collecting container is not immediately emptied.

Removing the water collecting container

1. Turn off the device.
2. Press on the hinged cover (1)
3. Remove the container (pos. 2) and empty is immediately.
t
e
r
o
u
t
l
e
t
t
e
r
o
u
t
l
e
t
and open it then
4. Re-insert the container. When inserting put the draining hose
(3) into the water collecting container. Make sure that the
container is correctly positioned.
icon and
.
5. Close the hinged enclosure cover.
6. Restart the air dehumidifier. The
E4 should no longer be displayed.
Icon and fault code are further displayed? Remove the
container again and re-insert it properly.

Continuous or extended operation

In the case of a high humidity of air it is recommended to
operate the air dehumidifier in continuous mode. In continuous
mode it is not needed to empty the water collecting container.
Proceed as follows:
1. Remove the water collecting container from the device.
2. Put the draining hose (3) through the hole
enclosure and pull it out of the device on the other side
3. Re-insert the collecting container in the device.
4. Close the hinged enclosure cover.
5. Place a large collecting container below the water draining.
Or:
Extend the water draining using a garden hose to pipe the water
into a drain channel.
icon and the fault code
in the
.
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

303997

Table des Matières