Start-Up - ADE Ylvie Mode D'emploi

Start-up

Inserting/changing battery
For use you require one battery of the type CR2032, 3 V (included). The battery
compartment is located on the underside of the device.
1. Remove the battery compartment cover.
2. Push the battery towards the contact springs under the big, angular retaining plate
and then press it down. The battery will snap into the holding lugs on the opposite
side and the battery will be held firmly in its holder.
Pay attention to the correct polarity (+/-). The plus pole (+) must point upwards.
3. Put the battery compartment cover back in place. The battery compartment cover
must snap securely into place.
Suggestions for changing the battery:
‚ A battery change is necessary when "Lo" or nothing at all is shown on
the display.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Dispose of batteries in an environmentally appropriate way (see "Disposal").
‚ Calibrate the scale, see "Positioning the scale".
Choosing the unit of measurement
When the scale is delivered, the unit of measurement is set to "kg" as standard.
However, the measurement can also be displayed in the English unit of measure "lb"
(pounds).
− Push the UNIT button on the back of the scale.
Pay attention to the display indicator.
Positioning the scale
1. Place the scale on an even, firm, and dry surface. Do not place the scale on carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
Bathroom Scale BE 1722
Start-up
17