EINHELL HKLO 2000 Mode D'emploi D'origine page 11

Anleitung_HKLO_2000_SPK7:_
11. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults. In the
event of any malfunctions or faults, please check the following before you contact your customer services.
Fault
Equipment does not work Power plug is not connected
Topple cut-out switch not pressed
The equipment does not heat The thermostat control is set too
low
Overheating guard has been
triggered
The switch is set to blowing
without heating function.
07.11.2011 14:48 Uhr
Possible cause Remedy
Connect the power plug
Place the machine on a level
surface.
Turn the thermostat control to the
right, to a higher temperature
Please note section 7.4
Set the heating function
Seite 11
GB
11