Publicité
①
①
④
8
②
CLOSE OPEN
CLOSE OPEN
②
⑤
English
TO OPERATE MOUTHVENT
The Monthvent is operated by simply pulling the vent control down to open,
pushing up to close. When the vent control is fully open, air is directed up
along the interior surface of the shield to help prevent fogging ① and when it
is in its mid-way position air is channeled back to further enhance the airflow
around the month and nose to help move hot moist air out faster ②.
TO OPERATE TOP VENTS
Simply push the switches/levers on each vent to open/close the vents.
NOTE:
Do not use oils or waxes to lubricate vents or other moving
parts. If you must lubricate such components, sparingly use the silicone
lubricant supplied with your helmet for eyeport trim dressing.
③
TO REMOVE/REPLACE SHIELD
To remove, place shield in the fully open position ①. Push the side pod
release lever from the front edge of the side pod backward ② to release
the side pod ③.
⑥
Then lower the shield until the brass stud of the shield moves into the red
hole of the base plate ④. Remove the shield from the spring clips ⑤＆
⑥, and repeat for the other side.
Publicité
Chapitres
