WARNING:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Never immerse the device or the base in water or other liquids.
CAUTION:
•
Do not use any wire brush or other abrasive objects.
•
Do not use any acidic or abrasive detergents.
•
Rinse the water container out with clean water. Then dry it
off with a cloth.
•
Clean the housing after use with a slightly damp cloth.
•
A permanent filter is located at the spout opening. To clean
the filter, pull it out when the lid is open. Rinse it out under
running water. If necessary, clean it with a nylon brush.
Reinsert the filter. To do so, use the guides on the inside of
the kettle.
Decalcification
•
The frequency of the decalcifying operation depends on
the hardness of the water and on how often the appliance
is used.
•
If the machine switches off before the water boils, it prob-
ably needs to be decalcified.
•
Please do not use vinegar but a commercially available
decalcification agent on the basis of citric acid. Only use
the quantities stated in the instructions.
NOTE:
After descaling the device boil fresh water in it several times
(approximately 3-4 times) in order to remove any residues.
Do not consume this water.
Troubleshooting
• It is not possible to switch the machine on.
Possible Cause:
The appliance has no power supply.
Remedy:
- Check the socket with another appliance.
- Plug in the mains plug correctly.
- Check the main circuit breaker.
Possible Cause:
The appliance is faulty.
Remedy:
Contact our service center or a specialist.
Cleaning
Possible Cause:
After being used without or with too little water the machine
has not cooled down sufficiently.
Remedy:
Allow the machine to cool down for 15 min.
• The machine switches off before the water has boiled.
Possible Cause:
The heating element is covered in scale or the electrical
circuit of the power socket is overloaded.
Remedy:
- Descale the machine as instructed.
- Check the mains connection.
•
The machine does not switch off.
Possible Cause:
The lid is not closed or the filter has not been inserted.
Remedy:
Close the lid until it locks into place, and/or reinsert the
filter.
Model: ................................................................... WKS 1581 CB
Power supply: ..........................................220 - 240 V~, 50/60 Hz
Power consumption: ..............................................1850 - 2200 W
Protection class: ......................................................................... I
Filling quantity: ..............................................................max. 1.5 l
Net weight: .......................................................... approx. 0.89 kg
The right to make technical and design modifications in the
course of continuous product development remains reserved.
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
Technical Data
31