Bosch Performance Line CX Notice D'utilisation D'origine page 11

– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics, top performance (eMTB is
only available in combination with drive units
BDU250P CX, BDU365, BDU450 CX and
BDU480 CX. This also requires a software update.)
Assistance level
ECO
TOUR
SPORT/eMTB
TURBO
A)
The assistance factor may vary in some models.
B)
Dynamic-progressive assistance level between TOUR and TURBO modes
Switching the push assistance on/off
The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7 mph.
The lower the selected gear, the lower the speed of
the push assistance function (at full power).
The push assistance function must only be used
u
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your on-board computer. After acti-
vation, press the + button within 3 s and keep it
pressed. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
The push assistance is switched off as soon as one of
the following occurs:
– You release the + button;
Bosch eBike Systems
Performance Line
(BDU490P)
60 %
140 %
240 %
340 %
– TURBO: Maximum assistance even at high pedaling
speeds, for biking sports
The requested motor output appears on the display of
the on-board computer. The maximum motor output
depends on which assistance level is selected.
A)
Assistance factor
Performance Line CX
(BDU480 CX)
60 %
140 %
B)
240/140–340 %
340 %
– the wheels of the eBike are locked (e.g. by applying
the brakes or hitting an obstacle);
– the speed exceeds 3.7 mph.
The push assistance function is subject to local regu-
lations; the way it works may therefore differ from the
description above. It can also be deactivated.
Switching bicycle lights on/off
On the model where the bike lights are powered by
the eBike system, the front light and taillight can be
switched on and off at the same time via the on-board
computer.
Before starting each journey, check that your bike
lights are working correctly.
English – 9
Cargo Line
60 %
140 %
240 %
400 %
0 275 U07 XD4 | (09.04.2020)