Rear Panel - Alto Professional TS3 Série Guide D'utilisation

Features

Rear Panel

1. AC Input: Use the included power cable to connect this
input to a power outlet. Make sure the Power Switch is
set to off when connecting or disconnecting the cable.
2. Fuse: If the unit's fuse is broken, lift this tab to replace
the fuse. Replace it with a fuse with an appropriate rating
(printed under the unit's power cable input). Using a fuse
with an incorrect rating can damage the unit and/or fuse.
Note: On the TS308 model, the fuse is located next to the
power switch rather than the AC input.
3. Power Switch: Use this switch to power the loudspeaker
on or off. Make sure the Volume knob is set to its
minimum (counterclockwise) position before turning it on.
4. Power LED: This LED lights up when the loudspeaker is on.
5. Volume: Turn this knob to adjust the loudspeaker's volume.
When using an audio source such as a mixer, CD/MP3
player or audio preamp, follow the outer/Line level band
indicator. In most circumstances, you will not need to turn
the volume beyond 0 dB. If your audio source has
unusually low output, you may turn the Volume knob past
0 dB, but not past the Signal Limit indicator.
When using a microphone or instrument audio source,
follow the inner/Mic level band indicator. Because the
mic and instrument level is typically lower than a line
level, you can use the full rotation of the Volume knob.
Please see Setup > Volume Control
6. Input: Use a standard XLR or 1/4" (6.35 mm) cable (not
included) to connect your audio source to this input.
7. Mix Out: Use a standard XLR cable (not included) to
connect this output to the input of another loudspeaker
(i.e., another TS3 loudspeaker).
8. Signal/Limit LED: This LED lights up green when an
audio signal is sent to the loudspeaker—it flashes at
lower levels and lights solidly at higher levels. The LED
lights up red when output limit/protection is active—if the
LED is lit red continuously, reduce the volume of your
audio source.
9. Contour: Engage (depress) this button to emphasize low
and high frequencies by +3 dB. Disengage (raise) the
switch for a flatter response for live performance or for
maximum output.
10. Ground Switch: Engage (depress) this switch to reduce
hum or noise.
8
to learn more.
5 5
6 6
1
2
4
9
10
8
7
3