Rear Panel Overview - Alto Professional TS II2PRO TRUESONIC Guide D'utilisation Rapide

BOX CONTENTS
•
TRUESONIC speaker
•
Power cable
•
Quickstart Guide
•
Safety Instructions & Warranty Information Booklet
CONNECTION DIAGRAM / INSTALLATION
Microphones*
Speaker
*Note: Microphones, mixer,
and cables are not included.

REAR PANEL OVERVIEW

1. POWER INPUT – Connect the included power cable to
this input and connect the other end of the cable to a
power source. Make sure the speaker's POWER
SWITCH is set to "off" when plugging and unplugging the
cable.
2. POWER SWITCH – Turns the speaker on/off. Make sure
the VOLUME knob is set to "zero" before turning it on.
3. POWER LED – Illuminates when the speaker is on.
4. VOLUME – Turn this knob to adjust the speaker's
volume.
5. INPUT – Use a standard 1/4" TRS or XLR cable (not
included) to connect your sound source to this input.
6. MIX OUT – Use a standard XLR cable (not included) to
connect this jack to the input of another speaker (i.e.,
another TRUESONIC speaker).
7. SIGNAL LIMIT LED – Illuminates when the audio signal
being sent to the speaker is "clipping" or distorting. If this
light illuminates frequently or steadily, reduce the volume
of your sound source.
8. CONTOUR – Engage (depress) this switch to emphasize
low and high frequencies by +3 dB. Disengage the switch for flatter response for live performance or for
maximum output.
9. GROUND SWITCH – Press this switch to reduce hum or noise.
Power
Mixer*
Power
INSTALLATION:
This speaker should be installed on a
stand on the floor, according to its
maximum weight, or suspended from its
suspension points (M10 x 1.5PH, 30mm
length) (see example image). We do
NOT recommend suspending multiple
speakers in a vertical array.
Speaker
1
2
Example:
7
4 4
3
5 5
6
2
Eyebolt
Dust cover
Suspension
point
8
9