MicroPower Sharp 20 Mode D'emploi page 10

The battery charger is produced in different mains voltage variations. Check that the
power supply at the site of the installation complies with the rate voltage according to
the information on the battery charger's rating plate.
The recommended mains fuse is specified on the battery charger's rating plate.
The battery charger is connected to the mains voltage via a cable with a plug to an
earthed wall socket.
Connect the battery charger as per figure 3. The red cable is connected to the
battery's positive pole and the black or blue cable is connected to the battery's nega-
tive pole. Carefully check the marking on the battery.
Upon request, the battery can be permanently connected or detachable.
Operation
Cable connections and control panel
Sharp 20 P4 (figure 4)
1. Mains switch
2. Mains cable
3. Battery cables
Sharp 20 P6 figure 5)
1. Mains cable
2. Battery cables
3. Reset button
Charging
In the case of danger, disconnect the mains voltage by pulling out the plug from
the wall socket.
Connecting a battery
1. Check that the battery charger is turned off. The switch on the panel should be in
the 0-position (applies to Sharp 20 P4). Battery charger Sharp 20 P6 can
be continuously to the mains.
2. Check the wiring and adapter to ensure that there is no visible damage.
3. Connect the battery to the battery charger.
4. Start the battery charger by setting the switch on the panel to the 1-position
(applies to Sharp 20 P4). Battery charger Sharp 20 P6 automatically starts
charging when the battery is connected. Yellow LED lights. Charging time will vary
depending on the type of battery and the degree of discharge.
10
4. LED
5. Program switch
4. LED
5. Program switch
WARNING!