SEVERIN KGK 8905 Mode D'emploi page 22

Installation measures
If the appliance is placed sideways on a wall,
you will leave a lateral gap of at least 60 mm,
so that the doors of the appliance can open
in a 90-degree angle. In order to be able to
remove the VeggiBox and the ZeroBox com-
pletely from the appliance, detach the bottle
compartment if necessary.
Width (W) Depth (D)
540 mm
A B
915 mm 1090 mm
Height (H)
576 mm 1700 mm
C E
125° 30 mm 300 mm
Ventilation
The air warmed behind the appliance needs
to circulate freely. For this reason, the circula-
tion of air cannot be compromised.
Caution! Do not cover possible existing
ventilation openings in the back area of the
top cover plate!
Connection
• Before you connect the appliance, you have
to make sure that itself and the power plug
do not show any transport damages.
• Connect the appliance only to a shockproof
outlet. The mains voltage has to correspond
to the one stated on the tool identification
plate.
• The appliance complies with the guidelines
that are obligatory for CE marking.
• Do not connect the appliance to an inverter
• The power plug should not touch the back-
side, in order to avoid possible vibration
noise.
• The appliance can be put into operation by
plugging the mains plug into the point.
• A complete switching-off only occurs by
pulling the mains plug.
Regulate the Temperature in the Cooling Room
F
Repeatedly press the "SET" button on the
panel until the desired setting or the "Fast
cool" indicator lights up. Setting 3 is the op-
timum temperature for normal use. At 4 and
5, the temperature is lower. At 1 and 2, it is
higher. Use a thermometer to check that the
desired temperature has been reached in the
refrigerator and freezer.
- 22 -