Beper 50.929B Manuel D'instructions page 17

Steam iron Use instructions
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.
WATER SPRAY
Check that the tank (2) is full of water, direct the spray (1) forward the clothes. Press se-
veral times the water switch (5).
When used for the first time, it is recommended to press several times on water switch (5)
before you obtain the desired spray.
Attention: do not use water spray function on silk.
DRY IRONING
Set the steam indicator (3) on in order to not to use steam function. Set the soleplate
temperature by using the thermostat (8).
The light indicator (7) illuminates and switch off when the soleplate is at good temperatu-
re.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
FILL AND EMPTY THE TANK
This has to be made only when the appliance is unplugged.
Always dry the iron or hands before unplug the appliance after filling the tank.
Make sure the temperature indicator (8) is on "min" and steam indicator (3) is on .Rai-
se the tank lid (2) and slowly fill using a funnel
Do not exceed the maximum limit of the tank.
Do not introduce water into the iron, because of electric shock risks. Close the tank lid (2)
when is full and plug the appliance to the socket.
It is possible to use tap water as well as demineralised water if tap water is to hard.
After ironing, unplug the appliance from the socket and empty the tank.
To empty the tank turn over the iron above the sink (or other).
Otherwise place the iron in vertical position and plug it to the socket.
Select the temperature indicator (8) on "MAX" and steam indicator (3) on steam symbol
and let the steam come out from the iron by pressing steam switch (4).
17