Preparing The Mower For Long-Term Storage; Ordering Replacement Parts; Disposal And Recycling - MIGROS DO IT+GARDEN BM 42 Mode D'emploi

7.2.7 Repairs
After any repair or maintenance work, check that
all safety-related parts are in place and in proper
working order.
All parts which may cause injury must be kept
where they are inaccessible to children or others.
Important: In accordance with product liability
legislation we are not liable for any damages
caused by improper repairs or the use of spare
parts that are not original spare parts or parts
approved by us. In addition, we are also not liable
for any damages arising from improper repairs.
Such work should be performed by a customer
services workshop or authorized specialist. The
same applies to accessory parts.
7.2.8 Times of use
Lawn mowers are only permitted to be used on
workdays between the hours of 7.00 a.m. and 7.00
p.m. Please comply with statutory regulations,
which may vary from location to location.
7.3 Preparing the mower for long-term
storage
Caution: Do not empty the petrol tank in
enclosed areas, near fire or when smoking. Petrol
fumes can cause explosions and fire.
1. Empty the petrol tank with a petrol suction
pump.
2. Start the engine and let it run until any
remaining petrol has been used up.
3. Change the oil at the end of every season. To
do so, remove the used engine oil from a warm
engine and refill with fresh oil.
4. Remove the spark plug from the cylinder head.
Fill the cylinder with approx. 20 ml of oil from an
oil can. Slowly pull back the starter handle, which
will bathe the cylinder wall with oil. Screw the
spark plug back in.
5. Clean the cooling fins of the cylinder and the
housing.
6. Be sure to clean the entire machine to protect
the paint.
7. Store the machine in a well-ventilated place.
7.4 Preparing the mower for transportation
1. Empty the petrol tank (see item 7.3.1).
2. Always let the engine run until it has used up
the remainder of petrol in the tank.
3. Empty the engine oil from the warm engine.
4. Remove the spark plug boot from the spark
plug.
5. Clean the cooling fins of the cylinder and the
housing.
6. Remove the start tension cable from the hook
(Fig. 8). Slacken the wing nuts and fold down the
upper push bar.
7. Wedge a few layers of corrugated cardboard
between the upper and lower push bars and the
engine in order to prevent any chafing.

7.5 Ordering replacement parts

Please quote the following data when ordering
replacement parts:

8. Disposal and recycling

8. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of
as special waste. Ask your dealer or your local
council.
59