HQ Power VDLPROM12 Mode D'emploi page 6


Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

Make sure there is no flammable material within a 0.5 m radius of the device.

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. Do not connect it to a dimming pack.

The installation has to be approved by an expert before the device is taken into service.
5. Use
After connecting the devices to the mains, the mirror ball motor will rotate at 3 RPM, the lamp will be on,
the colour wheel will be turning and the stroboscope will flash. By aiming the spot towards the mirror
ball, you will obtain a beautiful, colourful effect.
6. Cleaning and Maintenance

All screws should be tightened and free of corrosion.

The housing, the lenses, the mounting supports and the installation location should not be deformed,
modified or tampered with e.g. do not drill extra holes in mounting supports, do not change the
location of the connections, ...

Mechanically moving parts must not show any signs of wear and tear.

The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.

Disconnect the device from the mains prior to maintenance activities.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts, apart from the lamp and the colour wheel (see
"4. Installation").

Contact your dealer for spare parts if necessary.

Check regularly if the key ring or chain shackles have been deformed. If so, demount the mirror ball
immediately.
7. Technical Specifications
motor
power supply
power consumption
rotation speed
dimensions
total weight
max. diameter of mirror ball
max. load
PAR-36 pin spot
power supply
power consumption
dimensions
weight
lamp
colour wheel with motor
rotation speed
dimensions
colours
V. 01 – 08/12/2014
VDLPROM12
240 VAC, 50 Hz
4 W
1.5 RPM
 110 x 58 mm
0.3 kg
30 cm (12")
3 kg
240 VAC, 50 Hz
30 W
150 x 120 x 115 mm
1 kg
PAR-36 [order code LAMP36/2]
2.5 RPM
 220 mm
red, yellow, blue, green, purple
6 ©Velleman nv