HQ Power VDLPROM12 Mode D'emploi page 4


A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

This device falls under protection class I. It is therefore essential that the device be earthed. The
power plug must only be plugged into a protection class I outlet. Have a qualified person carry out
the electric connection.

Make sure that the available voltage does not exceed the voltage stated in the specifications of this
manual.

Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.

Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by
the plug only.

There may be some smoke or a particular smell when the device is activated for the first time. This is
normal and any smoke or smell will gradually disappear.

Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.

Replace the shields, lenses or UV screens if they have become visibly damaged (e.g. cracks, deep
scratches) to such an extent that their effectiveness is impaired.

Replace the lamp if it has become damaged or thermally deformed.

Note that damage caused by user modifications to the device are not covered by the warranty.

Keep the device away from children and unauthorised users.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

This set includes a mirror ball and pin spot for use at home, on stages, in discotheques, in theatres
etc.

The VDLPROM12 should only be used indoors with an alternating current of 230 VAC, 50 Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

Do not shake the device. Avoid brute force when installing or operating the device.

Select a location where the device is protected against extreme heat (see "7. Technical
Specifications"), dust and moisture. Respect a minimum distance of 0.5m between the device's light
output and any illuminated surface.

Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
4. Installation
Lamps

Only fit or replace a lamp when the device is unplugged from the mains.

Only operate the device with a fastened lamp.

Let a lamp cool down before replacing it as the temperature of a lamp can reach 150°C during
operation.

Do not install lamps with a higher wattage. They get hotter than this device was designed for.
V. 01 – 08/12/2014
VDLPROM12
4 ©Velleman nv