Manufacturer's Warranty; Spare Parts Lists - REMS Nano Notice D'utilisation

eng
5.4. Fault: Electric pipe cutter, cordless electric pipe cutter does not start.
Cause:
● Mains lead defective (REMS Nano).
● Power tool defective.
● Worn carbon brushes.
● Battery flat or defective (REMS Akku-Nano).
● Feeding pressure too high.
5.5. Fault: Cutting wheel becomes blunt or breaks out after 1 or 2 cuts.
Cause:
● Cutting in a cutting notch in which the previous cutting wheel already
became blunt or was damaged.
● Unsuitable cutting wheel.
● Pipe material is unsuitable for cutting.
5.6. Fault: Cutting of the pipes leaves marks on the outside of the pipes.
Cause:
● Rollers of the pipe rest (6) soiled.
● Rollers of the pipe rest (6) damaged.
6. Disposal
REMS Nano, REMS Akku-Nano, rapid charger and batteries may not be thrown
in the household waste when they are finished with. They must be disposed of
according to the legal regulations. Lithium batteries and battery packs of all
battery systems may only be disposed of in the discharged state, all contacts
of incompletely discharged lithium batteries and battery packs must be covered
with insulating tape.
7. Manufacturer's Warranty
The warranty period shall be 12 months from delivery of the new product to the
first user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference in an unassembled condition. Replaced products and parts
shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to make claims against the
seller under the warranty terms, shall not be affected. This manufacturer's
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).

8. Spare parts lists

For spare parts lists, see www.rems.de → Downloads → Parts lists.
10
Remedy:
● Have the mains lead changed by qualified personnel or an authorised REMS
customer service workshop.
● Have the power tool checked/repaired by an authorised REMS customer
service workshop.
● Have the motor changed by an authorised REMS customer service workshop.
● Charge the battery with the Li-Ion/Ni-Cd rapid charger or change the battery.
● Reduce feeding pressure.
Remedy:
● Place the cutting wheel next to the notch with the remaining fragments.
● Select and change cutting wheel according to the pipe to be cut.
● Only use approved pipes, see 1.3.
Remedy:
● Clean rollers with machine cleaner REMS CleanM (Art. No. 140119), then
protect against rust.
● Change rollers.
eng