Technical Data; Installation - IKEA FROSTIG SC136 Mode D'emploi

ENGLISH
Problem
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Remove the
screw from
the lamp
cover.
2. Remove the
lamp cover.
3. Replace the
lamp with
one of the
same power
and specifically designed for household
appliances. (the maximum power is
shown on the lamp cover).

Technical data

Dimensions
Height
Width
Depth
Net Volume
Defrost System
Energy Consumption
Noise Level
Energy Class

Installation

Caution! Read the "Safety
Information" carefully for your safety
Possible cause
The temperature regulator is
not set correctly.
815 mm
596 mm
550 mm
136 Litre
auto
0,340 kWh/24h
36 dB (A)
A+
Solution
Set a higher/lower tempera-
ture.
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light
comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
the assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
The technical infor-
mation are situated
in the rating plate on
the internal left side
of the appliance and
in the energy label.
and correct operation of the appliance
before installing the appliance.
12